Door Control Receiver: Inspection

INSPECT DOOR CONTROL RECEIVER

Fig 1: Identifying Door Control Receiver Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Check the voltage and resistance according to the value(s) in the table below.

Standard

TESTER CONNECTION SPECIFIED CONDITION TABLE

Tester Connection.	Specified Condition
5 (+B) - Body ground	10 to 14 V
1 (E) - Body ground	Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.

Reconnect the connector and check the voltage according to the value(s) in the table below.

Standard voltage

TESTER CONNECTION SPECIFIED CONDITION TABLE

Tester Connection	Condition	Specified Condition
2 (RDA) - Body ground	No key in ignition key cylinder, all doors closed and each transmitter switch OFF → ON	Below 1 V → Approx. 6 to 7 V → Below 1 V

If the result is not as specified, the receiver may have a malfunction.