Data List/Active Test
- READ DATA LIST
HINT:
Using the DATA LIST displayed on the intelligent tester, you can read the value of the switches, sensors, actuators, etc. without parts removal. Reading the DATA LIST as the first step in troubleshooting is one way to shorten the labor time.
- Connect the intelligent tester (with CAN VIM) to the DLC3.
- Turn the ignition switch to the ON position.
- Turn the tester on.
- Enter the following menus: DIAGNOSIS / OBD / MOBD / IMMOBILIZER / DATA LIST.
- Check the values by referring to the table below.
Transponder key ECU:
TESTER DISPLAY MEASUREMENT CONDITION TABLETester Display Measurement Item/Range Normal Condition Diagnostic Note KEYSW Unlock warning switch signal / ON or OFF ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder- IG SW Ignition switch signal / ON or OFF ON: Ignition switch on
OFF: Ignition switch off- IMMOBILIZER Immobilizer system status / SET or UNSET UNSET: Ignition switch on
SET: Without key- RESPONSE Transponder chip data / NG or OK NG: Data error
OK: Data OK- FRAME Transponder chip data / NG or OK NG: Data error
OK: Data OK- SERIAL NUMBER Transponder chip data / NG or OK NG: Data error
OK: Data OK- ENCRYPT CODE Transponder chip data / NG or OK NG: Data error
OK: Data OK- STATUS Transponder chip data / NG or OK NG: Data error
OK: Data OK- BCC Transponder chip data / NG or OK NG: Incorrect data being sent.
OK: Correct data being sent.- SUB KEY Sub key code signal / NOMATCH or MATCH NOMATCH: Non matching sub key code is sent.
MATCH: Sub key code is sent.- MASTER KEY Master key code signal / NOMATCH or MATCH NOMATCH: Non matching master key code is sent.
MATCH: Master key code is sent.- REGIST SUB CODE Number of registered sub key / min. 0, max. 15 Number of registered sub key. - REGIST MAS CODE Number of registered master key / min. 0, max. 15 Number of registered master key. - REG CODE SPAC Memory space for key codes registration / NOT FUL or FULL NOT FUL: More key code registration possible.
FULL: No more key code registration possible.- +B Power source / BRAKE or NORMAL BRAKE: Power source open.
NORMAL: Power source normal.- ANTENNA COIL Antenna coil condition / NORMAL or FAIL NORMAL: Antenna coil is normal.
FAIL: Antenna coil is malfunctioning.- - PERFORM ACTIVE TEST
HINT:
Performing the ACTIVE TEST using the intelligent tester allows the relay, VSV, actuator, etc. to operate without removing any parts. Performing the ACTIVE TEST as the first step in troubleshooting is one way to shorten labor time.
- Connect the intelligent tester (with CAN VIM) to the DLC3.
- Turn the ignition switch to the ON position.
- Turn the tester on.
- Enter the following menus: DIAGNOSIS / OBD/ MOBD / IMMOBILIZER / ACTIVE TEST.
Transponder key ECU:
TESTER DISPLAY MEASUREMENT CONDITION TABLETester Display Test Part Control Range Diagnostic Note SECURITY INDIC Turn security indicator ON / OFF -