FixVault
Home › Lexus › 2007 › IS 250 AWD › Repair and Diagnosis › Accessories & Equipment › Warning Systems › Park Assist/Monitoring › Ultrasonic Sensor › Installation

Ultrasonic Sensor: Installation

  1. INSTALL NO. 1 ULTRASONIC SENSOR 
    1. Install the No. 1 ultrasonic sensor to the rear bumper.
    2. Install the sensor retainer as shown in Fig 1 .
      Fig 1: Installing No. 1 Ultrasonic Sensor
      G04050634Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the sensor connector.
  2. INSTALL NO. 2 ULTRASONIC SENSOR 
    1. Install the No. 2 ultrasonic sensor to the rear bumper.
    2. Install the sensor retainer as shown in Fig 2 .
    3. Connect the sensor connector.
    Fig 2: Installing No. 2 Ultrasonic Sensor
    G04050635Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL REAR BUMPER ASSEMBLY 
  4. INSTALL REAR BUMPER PLATE 
  5. CONNECT LUGGAGE ROOM WIRE 
  6. INSTALL SIDE LUGGAGE COMPARTMENT TRIM COVER 
  7. INSTALL LUGGAGE COMPARTMENT TRIM HOOK 
  8. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER 
  9. INSTALL ROPE HOOK 
  10. INSTALL ROOM LIGHT ASSEMBLY 
  11. INSTALL ROPE HOOK ASSEMBLY 
  12. INSTALL REAR LUGGAGE COMPARTMENT TRIM COVER 
  13. INSTALL DECK SIDE TRIM BOX RH 
  14. INSTALL DECK SIDE TRIM BOX LH 
  15. INSTALL LUGGAGE COMPARTMENT TRIM COVER 
  16. INSTALL NO. 1 ULTRASONIC SENSOR 
    1. Install the No. 1 ultrasonic sensor to the front bumper.
    2. Install the sensor retainer as shown in Fig 3 .
    3. Connect the sensor connector.
    Fig 3: Installing Sensor Retainer
    G04050636Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  17. INSTALL FRONT BUMPER ASSEMBLY 
  18. INSTALL COOL AIR INTAKE DUCT SEAL 
  19. VEHICLE PREPARATION FOR FOG LIGHT AIM (See  ADJUSTMENT  ) 
  20. PREPARATION FOR FOG LIGHT AIMING (See step 2 in  ADJUSTMENT  ) 
  21. FOG LIGHT AIMING INSPECTION (See step 3 in  ADJUSTMENT  ) 
  22. FOG LIGHT AIMING ADJUSTMENT (See step 4 in  ADJUSTMENT  ) 
About FixVault