FRONT SPEED SENSOR (for 2WD): Installation

INSTALL FRONT SPEED SENSOR
1. Wipe off sealant attached to the front speed sensor's fitting surface with white gasoline.
  NOTE: Prevent foreign matter from attaching to the sensor rotor.
2. Install a new front speed sensor to the hub and bearing assembly. The front speed sensor connector should be placed in the upper position.
  
  Fig 1: Identifying Front Speed Sensor To Hub And Bearing Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using the SST and press, install the skid control sensor onto the hub and bearing.
  SST 09214-76011
  NOTE:
  - Keep the sensor away from magnets.
  - Do not use a hammer on the front speed sensor.
  - Check that there is no foreign matter such as iron chips on the front speed sensor's detecting portion.
  - Slowly press the front speed sensor straight.
    
    Fig 2: Identifying Skid Control Sensor Onto Hub And Bearing
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT AXLE HUB SUB-ASSEMBLY (See INSTALLATION )
INSPECT FRONT AXLE HUB BEARING FOR LOOSENESS (See ON-VEHICLE INSPECTION )
INSPECT FRONT AXLE HUB FOR RUNOUT (See ON-VEHICLE INSPECTION )
INSTALL FRONT DISC (See INSTALLATION (For IS350) INSTALLATION (For IS250) )
INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY (See INSTALLATION )
CONNECT FRONT SPEED SENSOR
1. Connect the speed sensor connector to the front speed sensor.
  NOTE: Do not twist the sensor wire.
INSTALL FRONT WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
INSPECT SPEED SENSOR SIGNAL
HINT:

(See TEST MODE PROCEDURE )

Fig 3: Identifying Speed Sensor Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002