Scuff Plate Light: Inspection

INSPECT SCUFF PLATE LIGHT

Measure the voltage according to the value (s) in the table below.

Standard voltage LH Side:

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Condition	Specified Condition
Q8-2 (+) - Q8-1 (-)	Any door Is opened	10 to 14 V
Q8-2 (+) - Q8-1 (-)	All doors are closed	Below 1 V

RH Side:

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Condition	Specified Condition
P2.2 (+) - P2-1 (-)	Any door Is opened	10 to 14 V
P2-2 (+) - P2-1 (-)	All doors are closed	Below 1 V

Fig 1: Identifying Scuff Plate Light Connector Terminals

If the result is not as specified, repair or replace the wire harness or connector.

Connect the (+) lead from the battery to terminal 2 and the (-) lead to terminal 1.

Fig 2: Identifying Scuff Plate Light Connector Terminals
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Check that the scuff plate light comes on.
OK: Comes on

If the result is not as specified, replace the scuff plate.