Inspection Procedure

1. Remove the outside handle.
2. Disconnect the antenna and door oscillator connectors.
   Fig 1: Identifying Electrical Key Oscillator And Antenna Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard resistance 

   ELECTRICAL KEY OSCILLATOR - ANTENNA
   
   

   Tester Connection (Symbols)	Condition	Specified Condition
   o1-2 (ANT2) - o2-8 (ANT2) ((1))	Always	Below 1 Ω
   o1-6 (SGT2) - o2-2 (SGT) ((1))	Always	Below 1 Ω
   o1-5 (ANT1) - o2-3 (ANT1) ((1))	Always	Below 1 Ω
   o1-2 (ANT2) - Body ground ((1))	Always	10 kΩ or higher
   o1-6 (SGT2) - Body ground ((1))	Always	10 kΩ or higher
   o1-5 (ANT1) - Body ground ((1))	Always	10 kΩ or higher
   n1-2 (ANT2) - n2-8 (ANT2) ((2))	Always	Below 1 Ω
   n1-6 (SGT2) - n2-2 (SGT) ((2))	Always	Below 1 Ω
   n1-5 (ANT1) - n2-3 (ANT1) ((2))	Always	Below 1 Ω
   n1-2 (ANT2) - Body ground ((2))	Always	10 kΩ or higher
   n1-6 (SGT2) - Body ground ((2))	Always	10 kΩ or higher
   n1-5 (ANT1) - Body ground ((2))	Always	10 kΩ or higher
   (1) Driver side (2) Driver side

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Replace the door outside handle.
2. Check that the entry LOCK/UNLOCK function operates normally.

   OK: 

   Entry LOCK/UNLOCK function operates normally. 

NG: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE  

OK: END (DOOR OUTSIDE HANDLE IS DEFECTIVE)