FixVault
Home › Lexus › 2007 › LS 460 › Repair and Diagnosis › External Pages › Different car › Section 509 (Continuously Variable Transmission (CVT)) › DTC P1701 Transmission Control Module (Power Supply) › DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-II 

  1. Turn ignition switch ON. (Do not start engine.)
  2. Select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-II.
    Fig 1: CONSULT-II Display - SELECT DIAG MODE
    G04899604Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Wait for at least 2 consecutive seconds.
  4. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
About FixVault