FixVault
Home › Lexus › 2007 › LS 460L › Repair and Diagnosis › Accessories & Equipment › Communication Devices › Can Communication › Can Communication System › DTC U0230 Lost Communication with Rear Gate Module › Inspection Procedure

Inspection Procedure

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
      CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
      NOTE:
      • After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
      • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
  2. CHECK FOR OPEN IN CAN BUS WIRE (POWER TRUNK LID CONTROL ECU BRANCH WIRE) 
    1. Disconnect the S43 power trunk lid control ECU connector.
      Fig 1: Identifying Terminals Of S43 Power Trunk LID Control ECU Connector
      G04953444Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Switch Condition Specified Condition
      S43-6 (CANH) - S43-5 (CANL) Engine switch off 54 to 69 Ω

    NG: REPAIR OR REPLACE POWER TRUNK LID CONTROL ECU BRANCH WIRE OR CONNECTOR (CANH, CANL) 

    OK: GO TO NEXT STEP 

  3. CHECK HARNESS AND CONNECTOR (POWER TRUNK LID CONTROL ECU - BATTERY AND BODY GROUND) 
    1. Connect the cable to the negative (-) battery terminal.
      NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
    2. Disconnect the S43 power trunk lid control ECU connector.
      Fig 2: Identifying Terminals Of S43 Power Trunk LID Control ECU Connector
      G04953445Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Condition Specified Condition
      S43-11 (GND) - Body ground Always Below 1 Ω
    4. Measure the voltage according to the value(s) in the table below.

      Standard voltage 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Switch Condition Specified Condition
      S43-12 (B) - Body ground Always 11 to 14 V
      S43-10 (ECUB) - Body ground Always 11 to 14 V
      S43-8 (IG) - Body ground Engine switch on (IG) 11 to 14 V

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: REPLACE POWER TRUNK LID CONTROL ECU  (See REMOVAL )

About FixVault