FixVault
Home › Lexus › 2007 › LS 460L › Repair and Diagnosis › Body & Frame › Exterior/Interior Trim › Interior › Rear Sunshade System › Data List / Active Test

Data List / Active Test

  1. DATA LIST 

    HINT:

    Using the intelligent tester or Techstream to read the Data List allows the values or states of switches, sensor, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may by discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
    1. Connect the intelligent tester or Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the tester on.
    4. Enter the following menus:
      1. Intelligent tester - Select: DIAGNOSIS / OBD/ MOBD / (desired menu) / DATA LIST / ALL /
      2. Techstream - Select: Body / (desired menu) / Data List /
    5. According to the display on tester, read the "Data List".
      1. Intelligent tester

        CENTER CONSOLE 

        INTELLIGENT TESTER - CENTER CONSOLE

        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        R SHADE SW Rear sunshade switch/ON or OFF ON: Rear sunshade switch is pressed
        OFF: Rear sunshade switch is not pressed        		 -

        REAR CONSOLE 

        INTELLIGENT TESTER - REAR CONSOLE

        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        R SHADE SW Rear sunshade switch/ON or OFF ON: Rear sunshade switch is pressed
        OFF: Rear sunshade switch is not pressed        		 -

        BODY NO. 4 

        INTELLIGENT TESTER - BODY NO. 4

        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        R-SHADE CLOSE Status of the rear sunshade close/YES or NO YES: Rear sunshade limit switch is OFF (Rear sunshade is lowered)
        NO: Rear sunshade limit switch is ON (Rear sunshade is raised)        		 -
      2. Techstream

        Center Console Switch 

        TECHSTREAM - CENTER CONSOLE SWITCH

        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        Rear Shade Switch Rear sunshade switch/ON or OFF ON: Rear sunshade switch is pressed
        OFF: Rear sunshade switch is not pressed        		 -

        Rear Console Switch 

        TECHSTREAM - REAR CONSOLE SWITCH

        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        Rear Shade Switch Rear sunshade switch/ON or OFF ON: Rear sunshade switch is pressed
        OFF: Rear sunshade switch is not pressed        		 -

        Body No. 4 

        TECHSTREAM - BODY NO. 4

        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        Rear Sunshade Close Status of the rear sunshade close/YES or NO YES: Rear sunshade limit switch is OFF (Rear sunshade is lowered)
        NO: Rear sunshade limit switch is ON (Rear sunshade is raised)        		 -
  2. ACTIVE TEST 

    HINT:

    Using the intelligent tester or Techstream to Perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    NOTE: When a Body No. 4 (luggage room junction block) related vehicle switch is ON, Active Test items related to the vehicle switch are prohibited (double operation prohibition). Check that the vehicle switches are OFF before performing Active Tests.
    1. Connect the intelligent tester or Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the tester on.
    4. Enter the following menus:
      1. Intelligent tester - Select: DIAGNOSIS / OBD/ MOBD / BODY NO. 4 / ACTIVE TEST /
      2. Techstream - Select: Body / Body No. 4 / Active Test/
    5. According to the display on tester, perform the "Active Test".
      1. Intelligent tester

        BODY NO. 4 

        INTELLIGENT TESTER - BODY NO. 4

        Tester Display Test Part Control Range Diagnostic Note
        R-SUNSHADE Rear Sunshade Operation Down, No or Up -
      2. Techstream

        Body No. 4 

        TECHSTREAM - BODY NO. 4

        Tester Display Test Part Control Range Diagnostic Note
        Rear Sunshade Operation Rear Sunshade Operation Down, No or Up -
About FixVault