FixVault
Home › Lexus › 2007 › LS 460L › Repair and Diagnosis › External Pages › Different car › Section 615 (Engine Mechanical) › Preparation › Special Service Tool

Special Service Tool

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.

SPECIAL SERVICE TOOL SPECIFICATION

Tool number
(Kent-Moore No.)
Tool name		 Description
ST0501S000
(-)
Engine stand assembly
1 ST05011000
(-)
Engine stand
2 ST05012000
(-)
Base
G04893953Courtesy of NISSAN MOTOR CO., U.S.A.
 Disassembling and assembling
KV101J0010
(J-47242)
Engine support table
G04885913Courtesy of NISSAN MOTOR CO., U.S.A.
 Removal engine and transmission assembly
KV10116200
(J-26336-A)
Valve spring compressor
  1. KV10115900 (J-26336-20) Attachment
  2. KV10109220 (-) Adapter
G04878205Courtesy of NISSAN MOTOR CO., U.S.A.
 Disassembling valve mechanism Part (1) is a component of KV10116200 (J-26336-A), but part (2) is not.
KV10107902
(J-38959)
Valve oil seal puller
G04899627Courtesy of NISSAN MOTOR CO., U.S.A.
 Removing valve oil seal
-
(J-39386)
Valve oil seal drift
G04878207Courtesy of NISSAN MOTOR CO., U.S.A.
 Installing valve oil seal
ST16610001
(J-23907)
Pilot bushing puller
G04878209Courtesy of NISSAN MOTOR CO., U.S.A.
 Removing crankshaft pilot bushing
KV10111100
(J-37228)
Seal cutter
G04874707Courtesy of NISSAN MOTOR CO., U.S.A.
 Removing steel oil pan and rear timing chain case
WS39930000
(-)
Tube presser
G04878211Courtesy of NISSAN MOTOR CO., U.S.A.
 Pressing the tube of liquid gasket
KV10112100
(BT-8653-A)
Angle wrench
G04878212Courtesy of NISSAN MOTOR CO., U.S.A.
 Tightening bolts for bearing cap, cylinder head, etc.
-
(J-44626)
Air fuel sensor Socket
G04899623Courtesy of NISSAN MOTOR CO., U.S.A.
 Loosening or tightening air fuel ratio A/F sensor
  1. 22 mm (0.87 in) 
KV10114400
(J-38365)
Heated oxygen sensor wrench
G04878214Courtesy of NISSAN MOTOR CO., U.S.A.
 Loosening or tightening rear heated oxygen sensor
  1. 22 mm (0.87 in) 
KV10117700
(J-44716)
Ring gear stopper
G04893964Courtesy of NISSAN MOTOR CO., U.S.A.
 Removing and installing crankshaft pulley
KV10109300
(-)
Pulley holder
G04885667Courtesy of NISSAN MOTOR CO., U.S.A.
 Holding pulley position
  1. 68 mm (2.68 in) 
  2. 8 mm (0.31 in) 
About FixVault