FixVault
Home › Lexus › 2007 › LS 460L › Repair and Diagnosis › External Pages › Different car › Section 636 (Brake System) › Disassembly And Assembly › Brake Master Cylinder › Disassembly and Assembly › Disassembly

Disassembly and Assembly: Disassembly

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • While working, cover the primary piston rod with a cloth to prevent it from being damaged.
  • Master cylinder assembly cannot be disassembled.
  • Do not drop parts. If a part is dropped, do not use it.
  1. Secure the flange of the cylinder body in a vise as shown.
    Fig 1: Securing Cylinder Body Flange Section In Vise
    G04876643Courtesy of NISSAN MOTOR CO., U.S.A.
    CAUTION:
    • Use copper plates or a cloth to cover the flange before securing it in a vise.
    • When securing the master cylinder assembly in a vise, be sure not to over-tighten the vise.
  2. Remove the pin from reservoir tank, using suitable tool approximately 4 mm (0.16 in) diameter.
    Fig 2: Identifying Reservoir Tank Mounting Pin
    G04876644Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Remove the master cylinder assembly from the vise.
  4. Remove the reservoir tank and grommets from the cylinder body and discard the grommets.
    CAUTION: Discard the grommets, do not reuse.
About FixVault