Component Inspection

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ACCELERATOR PEDAL POSITION SENSOR

Reconnect all harness connectors disconnected.
Turn ignition switch ON.

Check the voltage between ECM harness connector terminals under the following conditions.

VOLTAGE SPECIFICATION

ECM			Condition		Voltage (V)
Connector	+	-
	Terminal	Terminal
E10	81 (APP sensor 1 signal)	84 (Sensor ground)	Accelerator pedal	Fully released	0.65 - 0.87
				Fully depressed	More than 4.3
	82 (APP sensor 2 signal)	100 (Sensor ground)		Fully released	0.28 - 0.48
				Fully depressed	More than 2.0

Fig 1: Checking Voltage Between ECM Harness Connector Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal?

YES: INSPECTION END

NO: GO TO 2.

REPLACE ACCELERATOR PEDAL ASSEMBLY
1. Replace accelerator pedal assembly.
2. Go to "SPECIAL REPAIR REQUIREMENT ".
: INSPECTION END