ABSORBER CONTROL ACTUATOR (for Front Side): Inspection

INSPECT ABSORBER CONTROL ACTUATOR

Measure the resistance according to the value(s) in the table below.

Standard resistance

ABSORBER CONTROL ACTUATOR

Tester Connection	Condition	Specified Condition
1 (B+) - 3 (GND)	Always	12.0 to 12.8 Ω
2 (A+) - 3 (GND)	Always
4 (B-) - 3 (GND)	Always
5 (A-) - 3 (GND)	Always

Fig 1: Inspecting Absorber Control Actuator

G04944134

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Check the shaft stop position.
1. Connect the connector to the absorber control actuator.
2. Check the absorber control actuator operation (see OPERATION CHECK ).
  1. Enter TEST MODE and turn the engine switch on (IG).
  2. Check the shaft rotation when depressing the brake pedal.
    OK: Every time the brake pedal is depressed, the absorber control actuator rotates in the hard to soft direction in 15° intervals up to a maximum angle of 120°.
  Fig 2: Identifying Shift Range Angle
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002