DTC C1290/66 Steering Angle Sensor Zero Point Malfunction: Wiring Diagram

HINT:

This code is output when a problem occurs in the zero point calibration of the steering angle sensor and yaw rate sensor. Therefore, clear the stored zero point calibration data and correct the zero points.

1. Clear the zero point calibration data.
2. Perform a zero point calibration of the steering sensor and yaw rate sensor.

1. Clear the DTCs.
2. Turn the ignition switch ON.
3. Check if the same DTCs are recorded.

   Result: 

   RESULT
   
   

   Result	Proceed to
   DTC is output	A
   DTC is not output	B

   HINT:

   When the registered data is not equal to the input data, the DTC will be output.

B: END 

A: REPAIR CIRCUIT INDICATED BY OUTPUT DTC