Data List/Active Test

HINT:

Using the intelligent tester's DATA LIST allows switch, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

1. Connect the intelligent tester with CAN VIM to the DLC3.
   Fig 1: Connecting Intelligent Tester To DLC3 With CAN VIM

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Turn the ignition switch to the ON position.
3. Read the DATA LIST.

   BODY: 

   DATA LIST - BODY
   
   

   Item	Measurement Item/Display (Range)	Normal Condition	Diagnostic Note
   KEY UNLK WRN SW	Unlock warning switch signal/ON or OFF	ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder	-
   D DOR CTY SW	Driver side door courtesy switch signal/ON or OFF	ON: Driver side door is open OFF: Driver side door is closed	-

HINT:

Using the intelligent tester to perform ACTIVE TEST allows the operation or effects of actuators, relays, VSVs, and other items to be tested without removing any parts. This non intrusive inspection can be very useful as intermittent conditions or operation may be discovered before parts or wiring are disturbed. Using the ACTIVE TEST early in troubleshooting is one way to save diagnostic time. It is possible to view DATA LIST information on the intelligent tester while performing ACTIVE TEST.

1. Connect the intelligent tester (with CAN VIM) to the DLC3.
2. Turn the ignition switch to the ON position.
3. Perform the ACTIVE TEST.

   METER: 

   ACTIVE TEST - METER
   
   

   Item	Test Details	Diagnostic Note
   KEY REWIND BUZZR	Key reminder buzzer (OFF/ON)	Confirm that the vehicle is stopped with the engine idling