Inspection Procedure

1. Check the DATA LIST to ensure proper function of the front passenger door lock switch.

   BODY: 

   NORMAL CONDITION TABLE
   
   

   Item	Measurement Item/Display (Range)	Normal Condition	Diagnostic Note
   D/L SW-LOCK	Door lock switch signal/ON or OFF	ON: Door lock switch is pushed to LOCK position OFF: Door lock switch is not pushed to LOCK position	-
   D/L SW-UNLOCK	Door unlock switch signal/ON or OFF	ON: Door lock switch is pushed to UNLOCK position OFF: Door lock switch is not pushed to UNLOCK position	-

   OK: The display is as specified in the normal condition. 

NG: Go to step   2 

OK: OTHERS PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE  

1. Remove the door control switch assembly.
   Fig 1: Identifying Door Control Switch Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION REFERENCE TABLE
   
   

   Tester Connection	Condition	Specified Condition
   2 - 3	Lock	Below 1 Ω
   2 - 3 1 - 2	OFF (Free)	10 kΩ or higher
   1 - 2	Unlock	Below 1 Ω

NG: REPLACE DOOR CONTROL SWITCH ASSEMBLY 

OK: Go to next step. 

1. Disconnect the door control switch assembly connector.
   Fig 2: Identifying Door Control Switch Assembly & Instrument Panel J/B Connectors Terminal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the instrument panel J/B connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION REFERENCE TABLE
   
   

   Tester Connection	Condition	Specified Condition
   D12-3 - 1J-3	Always	Below 1 Ω
   D12-1 - 1J-4	Always	Below 1 Ω
   D12-2 - Body ground	Always	Below 1 Ω

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: OTHERS PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE