FixVault
Home › Lexus › 2007 › RX 350 AWD › Repair and Diagnosis › Body & Frame › Door Locks › Door Lock › Wireless Door Lock Control System › Data List/Active Test

Data List/Active Test

  1. DATA LIST 

    HINT:

    Using the intelligent tester DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to shorten labor time.

    1. Connect the intelligent tester (with CAN VIM) to the DLC3.
    2. Turn the ignition switch ON
    3. Enter the following menus: DIAGNOSIS / OBD/ MOBD / BODY / DATE LIST.
    4. Read the DATA LIST according to the display on the tester.

      BODY: 

      DATA LIST - BODY

      Item (Display) Measurement Item/Display (Range) Normal Condition Diagnostic Note
      KEY UNLK WRN SW Unlock warning switch / ON or OFF ON: Ignition key is inserted
      OFF: Ignition key is not inserted      		 -
      IG SW Ignition switch signal / ON or OFF ON: Ignition switch ON or START
      OFF: Ignition switch OFF or ACC      		 -
      WIRELESS OPER Wireless door lock control function / ON or OFF ON: Operates
      OFF: Does not operate      		 -
      HAZARD ANS BACK Hazard answer-back of wireless / ON or OFF ON: Operates
      OFF: Does not operate      		 -
      OPEN DOOR WARN Open door warning / ON or OFF ON: Operates
      OFF: Does not operate      		 -
      AUTO LOCK DELAY Automatic lock time / 60 s or 30 s 60 s: 60 seconds
      30 s: 30 seconds      		 -
      UNLOCK/2 OPER 2 times operation of wireless unlock / ON or OFF ON: All doors unlock when UNLOCK pressed twice
      OFF: All doors unlock when UNLOCK pressed once      		 -
      ALARM FUNCTION Panic function / ON or OFF ON: Operates
      OFF: Does not operate      		 -
      WIRLS BUZZ RESP Wireless door lock buzzer response / ON or OFF ON: Operates
      OFF: Does not operate      		 -
  2. ACTIVE TEST 

    HINT:

    Performing the ACTIVE TEST using the intelligent tester allows components such as the relay, VSV and actuator to operate without removing parts. Performing the ACTIVE TEST as the first step in troubleshooting is one way to shorten labor time.

    It is possible to display the DATA LIST during the ACTIVE TEST.

    1. Connect the intelligent tester to the DLC3.
    2. Turn the ignition switch ON.
    3. Enter the following menus: DIAGNOSIS / OBD/ MOBD / BODY / ACTIVE TEST
    4. According to the display on the tester, preform the ACTIVE TEST.

      HINT:

      The ignition switch must be turned to the ON position to proceed with the ACTIVE TEST using the intelligent tester.

      BODY: 

      ACTIVE TEST - BODY

      Item (Display) Vehicle Condition/Test Details Diagnostic Note
      HAZARD Turns turn signal flasher relay ON/OFF -
      BUZZ RESP SOUND Turns wireless door lock buzzer ON/OFF -
About FixVault