Front Axle Hub: Reassembly

INSTALL FRONT AXLE HUB LH BEARING
1. Using SST(s) and a press, install a new front axle hub LH bearing to the steering knuckle LH.
  SST 09950-60020 (09951-00810), 09950-70010 (09951-07100)
  
  Fig 1: Using SST(s) & Press To Install New Front Axle Hub LH Bearing To Steering Knuckle LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL DISC BRAKE DUST COVER FRONT LH
1. Place the disc brake dust cover front LH and using a torx wrench (T30), torque the 4 bolts.
  Torque: 8.3 N*m (85 kgf*cm, 74 in.*lbf)
  
  HINT:
  
  Torx is a registered trademark of Textron Inc.
INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
1. Using SST(s), and a press, install the front axle hub sub-assembly LH.
  SST 09608-32010, 09950-60020 (09951-00810), 09950-70010 (09951-07100)
  
  Fig 2: Installing Front Axle Hub Sub-Assembly LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT AXLE HUB LH HOLE SNAP RING
1. Using snap ring pliers, install a new front axle hub LH hole snap ring.
  
  Fig 3: Installing Front Axle Hub LH Hole Snap Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT WHEEL BEARING DUST DEFLECTOR NO.1 LH
1. Using SST(s) and a hammer, install the bearing dust deflector No. 1 LH.
  SST 09316-60011 (09316-00011, 09316-00031), 09608-32010
  
  Fig 4: Installing Bearing Dust Deflector No. 1 LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Align the hole for the speed sensor in the bearing dust deflector No. 1 LH with the steering knuckle.
INSTALL LOWER BALL JOINT ASSEMBLY FRONT LH
1. Install the lower ball joint assembly front LH and tighten the nut.
  Torque: 123 N*m (1,250 kgf*cm, 91 ft.*lbf)
2. Install a new cotter pin.
  NOTE: If the holes for the cotter pin are not aligned, tighten the nut up to 60° further.