Inspection Procedure
- READ VALUE OF DATA LIST (FRONT PASSENGER SIDE DOOR CONTROL SWITCH ASSEMBLY)
- Check the DATA LIST to ensure proper function of the front passenger door lock switch.
BODY (Body ECU):
DATA LIST - BODY (BODY ECU)Item Measurement Item / Display (Range) Normal Condition Diagnostic Note D/L SW-LOCK Door lock switch signal /ON or OFF ON: Door lock switch is pushed to LOCK position
OFF: Door lock switch is not pushed to LOCK position- D/L SW-UNLOCK Door unlock switch signal /ON or OFF ON: Door lock switch is pushed to UNLOCK position
OFF: Door lock switch is not pushed to UNLOCK position- OK: The display is as specified in the normal condition.
NG: GO TO step 2
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
- INSPECT DOOR CONTROL SWITCH ASSEMBLY
- Remove the door control switch assembly.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition 2 - 3 Lock Below 1 Ω 2 - 3 1 - 2 OFF (Free) 10 kΩ or higher 1 - 2 Unlock Below 1 Ω NG: REPLACE DOOR CONTROL SWITCH ASSEMBLY
OK: Go to next step
- CHECK WIRE HARNESS (DOOR CONTROL SWITCH ASSEMBLY - INSTRUMENT PANEL J/B)
- Disconnect the door control switch assembly connector.
- Disconnect the instrument panel J/B connector.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition D12-3 - 1J-3 Always Below 1 Ω D12-1 - 1J-4 Always Below 1 Ω D12-2 - Body ground Always Below 1 Ω NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE