How To Proceed With Troubleshooting

1. Check which of the following is installed: Dynamic laser cruise control. Parking assist monitor system.

1. Check can bus line (See CAN BUS LINE  ).

1. Select "BUS CHECK" (See DIAGNOSIS SYSTEM  ).

   Result 

   RESULT REFERENCE
   
   

   Symptom	Proceed to
   All the ECUs and sensors connected to the CAN communication system are displayed on the screen.	A
   An ECU or sensor not connected to the CAN communication system is displayed on the screen.	B
   More than one of the ECUs and sensors not connected to the CAN communication system are displayed on the screen. (If the displayed ECUs and sensors are only those relating to the 'ENGINE' and 'HV', proceed to B)	C

   NOTE:

   • The systems (ECUs, sensors) that adopt CAN communication vary depending on the vehicle and option settings. Check which systems (ECUs, sensors) are installed on the vehicle (See DIAGNOSIS SYSTEM  ).
   • Non-installed ECUs or sensors are not displayed. Do not mistake them for being in the communication stop mode.
   • If 2 or more ECUs or sensors are not displayed on the intelligent tester via the CAN VIM, perform troubleshooting for communication stop mode for each undisplayed ECU or sensor. (Open in one side of the CAN sub bus lines.)
   • If DTCs U0146-435 and P3108-594 are output and 'GATEWAY' is displayed in 'BUS CHECK' on the intelligent tester, refer to MULTIPLEX COMMUNICATION .

B : GO TO " COMMUNICATION STOP MODE TABLE  " 

C : GO TO "  1  " 

A : GO TO NEXT STEP. 

1. Confirm trouble according to the combination of output DTCs regarding the CAN communication system.

   HINT:

   Previous CAN communication system DTCs may be the cause if CAN communication system DTCs are output and all ECUs and sensors connected to the CAN communication system are displayed on the intelligent tester's "BUS CHECK" screen via CAN VIM.

NEXT: END