FixVault
Home › Lexus › 2007 › RX 400h AWD › Repair and Diagnosis › External Pages › Different car › Section 174 (Engine Immobilizer) › Engine Immobilizer System › ECU Power Source Circuit › Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT FUSE (ECU-B2) 
    1. Remove the ECU-B2 fuse from the engine room No. 2 relay block.
    2. Measure the resistance of the fuse.

      Standard resistance: Below 1 Ω 

    NG: REPLACE FUSE 

    OK: Go TO NEXT STEP. 

  2. CHECK WIRE HARNESS (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND) 
    1. Disconnect the E46 ECU connector.
    2. Measure the resistance and voltage of the wire harness side connector. (See Fig 1).

      Standard resistance 

      TESTER CONNECTION AND SPECIFIED CONDITION

      Tester Connection Specified Condition
      E46-16 (GND) - Body ground Below 1 Ω

      Standard voltage 

      TESTER CONNECTION AND SPECIFIED CONDITION

      Tester Connection Specified Condition
      E46-1 (+B) - Body ground 10 to 14 V
      Fig 1: Identifying E46 ECU Harness Connector
      G04490674Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

    OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

About FixVault