Room Light Assembly: Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE ROOM LIGHT ASSEMBLY
1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the room light lens.
  
  Fig 1: Removing Room Light Lens Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the 2 covers.
  
  Fig 2: Removing Covers Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws.
  
  Fig 3: Removing Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disengage the roof wire from the claw of the room light.
5. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the room light switch base.
6. Remove room light bulb No. 1.
  
  Fig 4: Removing Room Light Switch Base Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002