Front Axle Hub: Disassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE FRONT AXLE HUB HOLE SNAP RING
1. Using snap ring pliers, remove the hole snap ring.
  NOTE: When removing the hole snap ring, do not damage the magnetic rotor surface.
  
  Fig 1: Removing Front Axle Hub Hole Snap Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT AXLE HUB SUB-ASSEMBLY
1. Fix the steering knuckle in a vise between aluminum plates.
  NOTE: Do not overtighten the vise.
2. Using SST, remove the axle hub.
  SST 09520-00031
  
  Fig 2: Removing Axle Hub Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST, remove the hub bearing inner race from the axle hub.
  SST 09950-40011 (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04011, 09957-04010, 09958-04011), 09950-60010 (09951-00370)
  
  Fig 3: Removing Hub Bearing Inner Race Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT DISC BRAKE DUST COVER
1. Remove the dust cover by tapping the back side with a brass bar and hammer.
  
  Fig 4: Tapping Front Disc Brake Dust Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT AXLE HUB BEARING
1. Install the removed hub bearing inner race onto the outer side of the hub bearing.
2. Using SST and a press, remove the hub bearing from the steering knuckle.
  SST 09223-15020, 09387-00041 (09387-02010), 09950-60010 (09951-00630), 09950-70010 (09951-07100)
  
  Fig 5: Identifying Hub Bearing And SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002