FixVault
Home › Lexus › 2007 › RX 400h AWD › Repair and Diagnosis › External Pages › Different car › Section 266 (Axle) › Front Axle Hub Bolt › Installation

Front Axle Hub Bolt: Installation

WARNING: This page is about a different car, the 2008 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FRONT AXLE HUB BOLT 
    1. Install the washer and the nut onto a new hub bolt.
    2. Using a screwdriver or the equivalent to hold the axle hub, install the hub bolt by tightening the nut.
      3. Fig 1: Identifying Front Axle Hub Bolt With Screwdriver
      G05112033Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FRONT DISC  (See INSTALLATION )
  3. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY  (See INSTALLATION  )
  4. INSTALL FRONT WHEEL 

    Torque: 112 N*m (1,137 kgf*cm, 82 ft.*lbf) 

  5. FILL RESERVOIR WITH BRAKE FLUID  (See BRAKE FLUID )
  6. BLEED BRAKE LINE  (See BRAKE FLUID )
  7. CHECK FLUID LEVEL IN RESERVOIR  (See BLEEDING )
  8. CHECK FOR BRAKE FLUID LEAKAGE 
About FixVault