Ignition Switch: Inspection
WARNING: This page is about a different car, the 2008 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT IGNITION SWITCH ASSEMBLY
- Check the resistance.
- Using an ohmmeter, measure the resistance between the terminals.
Standard resistance
IGNITION SWITCH ASSEMBLYSwitch Condition Tester Connection Specified Condition LOCK - 10 kΩ or higher ACC 1 (AM1) - 3 (ACC) Below 1 Ω ON 1 (AM1) - 3 (ACC) - 4 (IG1) 7 (IG2) - 8 (AM2) Below 1 Ω START 1 (AM1) - 2 (ST1) - 4 (IG1) 6 (ST2) - 7 (IG2) - 8 (AM2) Below 1 Ω Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
If the result is not as specified, replace the ignition switch.
- Using an ohmmeter, measure the resistance between the terminals.
- Check the resistance.