Clutch Switch: Installation

WARNING: This page is about a different car, the 2008 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CLUTCH SWITCH ASSEMBLY
1. Fully loosen the lock nut of the clutch switch assembly.
2. Adjust the clutch switch until the threaded portion comes into contact with the cushion. Tighten the lock nut and ensure that the threaded portion is in contact with the cushion.
  Torque: 15 N*m (155 kgf*cm, 11 ft.*lbf)
3. Connect the connector.
INSTALL MAIN BODY ECU (DRIVER SIDE J/B)
1. Install the main body ECU with the 2 nuts.
  Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf)
  
  Fig 2: Identifying Main Body ECU And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT PANEL SIDE BRACKET
1. Install the instrument panel side bracket with the bolt.
  Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf)
  
  Fig 3: Identifying Instrument Panel Side Bracket And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER INSTRUMENT PANEL LH (See INSTALLATION )
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH (Se e INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PLATE (See INSTALLATION )
CONNECT HOOD LOCK CONTROL LEVER SUBASSEMBLY (See INSTALLATION )
INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (See INSTALLATION )
INSTALL COWL SIDE TRIM BOARD LH (See INSTALLATION )
INSTALL FOOTREST CLIP (See INSTALLATION )
INSTALL FRONT FLOOR FOOTREST (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE LH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)