How To Proceed With Troubleshooting

HINT:

Use these procedures to troubleshoot the theft deterrent system.

*: Use the intelligent tester.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 

   11 to 14 V 

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

3. INSPECT COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)* 
   1. Use the intelligent tester to check if the Multiplex Communication System (MPX) is functioning normally.

      Result: 

      RESULT REFERENCE
      
      

      Result	Proceed to
      MPX DTC is not output	A
      MPX DTC is output	B

   B:  GO to MULTIPLEX COMMUNICATION SYSTEM

   A: Go to next step 

4. PROBLEM SYMPTOMS TABLE 

   Result: 

   RESULT REFERENCE
   
   

   Result	Proceed to
   If fault is not listed in problem symptoms table	A
   If fault is listed in problem symptoms table	B

   B: Go to step  6

   A: Go to next step 

5. OVERALL ANALYSIS AND TROUBLESHOOTING 
   1. (see DATA LIST / ACTIVE TEST  )
   2. (see TERMINALS OF ECU  )
   3. Inspection

      (see ENGINE HOOD COURTESY SWITCH  , SECURITY HORN ASSEMBLY  and SECURITY INDICATOR LIGHT ASSEMBLY  )

6. ADJUST, REPAIR OR REPLACE 
7. CONFIRMATION TEST 

   NEXT: END