FixVault
Home › Lexus › 2008 › ES 350 › Repair and Diagnosis › External Pages › Different car › Section 77 (Starting) › Starter › Installation

Section 77 (Starting): Starter: Installation

WARNING: This page is about a different car, the 2007 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STARTER ASSEMBLY 
    1. Install the starter assembly with the 2 bolts.

      Torque: 37 N*m (380 kgf*cm, 28 ft.*lbf) 

    2. Connect the wire harness to terminal 30 and install the nut. Then, attach the terminal cap.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    3. Connect the terminal 50 connector to the starter assembly.
      Fig 1: Locating Starter Assembly Bolts
      G04975667Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
  3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY  (See INSTALLATION )
  4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL NO. 2 AIR CLEANER INLET  (See INSTALLATION )
  6. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  7. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  8. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL  (See INSTALLATION )
  10. PERFORM INITIALIZATION 
    1. Perform initialization procedure (See INITIALIZATION ).
      NOTE: Some vehicle systems require initialization after reconnecting the cable to the negative battery terminal.
About FixVault