Inspection Procedure

1. Disconnect the x2 display connector.
2. Disconnect the x1 receiver connector.
3. Measure the resistance according to the value (s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Switch Condition	Specified Condition
   x2-4 (VV-) - x1-2 (GND)	Always	Below 1 Ω
   x2-1 (VV+) - x1-1 (NTSC)	Always	Below 1 Ω
   x2-4 (VV-) - Body ground	Always	10 kΩ or higher
   x2-1 (VV+) - Body ground	Always	10 kΩ or higher
   x1-3 (SLD) - Body ground	Always	10 kΩ or higher

NG : REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 1: Identifying x2 Display Connector And x1 Receiver Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE