FixVault
Home › Lexus › 2008 › GS 350 AWD › Repair and Diagnosis › Engine Performance › Fuel Delivery › Fuel (2GR-FSE) › Fuel Pressure Sensor › Installation

Fuel Pressure Sensor: Installation

  1. INSTALL FUEL PRESSURE SENSOR 
    1. Install a new gasket to the fuel pressure sensor.
    2. Using SST, install the fuel pressure sensor to the No. 1 delivery pipe.

      SST 09922-10010 

      Torque: 24 N*m (240 kgf*cm, 18 ft.*lbf) for use 

      with SST 

      31 N*m (316 kgf*cm, 23 ft.*lbf) for use 

      without SST 

      HINT:

      • The torque for use with SST is the torque when SST is used at the position shown in the illustration.
      • Make sure SST and wrench are connected in a straight line.
        Fig 1: Installing Fuel Pressure Sensor To No. 1 Delivery Pipe
        G05286989Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the connector with the clamp.
  2. INSTALL NO. 1 FUEL PIPE  (See INSTALLATION  )
  3. CONNECT WATER HOSE JOINT  (See INSTALLATION  )
  4. INSTALL INTAKE MANIFOLD  (See INSTALLATION  )
  5. INSTALL INTAKE AIR SURGE TANK  (See INSTALLATION  )
  6. INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY  (See INSTALLATION )
    Fig 2: Locating Connector With Clamp
    G05286990Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE  (See INSTALLATION )
  8. CONNECT NO. 2 VENTILATION HOSE  (See INSTALLATION )
  9. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See INSTALLATION )
  10. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See INSTALLATION )
  11. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See INSTALLATION )
  12. INSTALL FRONT FENDER TO COWL SIDE SEAL LH  (See INSTALLATION )
  13. INSTALL FRONT FENDER TO COWL SIDE SEAL RH  (See INSTALLATION )
  14. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH  (See INSTALLATION )
  15. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH  (See INSTALLATION )
  16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  17. ADD ENGINE COOLANT  (See REPLACEMENT )
  18. INSPECT FOR COOLANT LEAK  (See ON-VEHICLE INSPECTION )
  19. INSPECT FOR FUEL LEAK  (See ON-VEHICLE INSPECTION  )
  20. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  21. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  22. INSTALL ENGINE ROOM SIDE COVER RH  (See INSTALLATION )
  23. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  24. CHECK FUNCTION OF THROTTLE BODY WITH MOTOR ASSEMBLY  (See REMOVAL )
  25. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.
About FixVault