FixVault
Home › Lexus › 2008 › GS 350 RWD › Repair and Diagnosis › Transmission › Automatic Trans › A760E Automatic Transaxle › Floor Shift Assembly › Removal

Floor Shift Assembly: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 
  3. REMOVE FRONT CONSOLE UPPER PANEL GARNISH  (See REMOVAL )
  4. REMOVE CONSOLE UPPER PANEL ASSEMBLY  (See REMOVAL )
  5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH  (See REMOVAL )
    Fig 1: Locating Floor Shift Gear Shifting Rod Sub-Assembly Nut
    G05288266Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH  (See REMOVAL )
  7. REMOVE CONSOLE BOX PLATE  (See REMOVAL )
  8. REMOVE CONSOLE BOX REGISTER ASSEMBLY  (See REMOVAL )
  9. REMOVE CONSOLE BOX  (See REMOVAL )
  10. REMOVE NO. 2 CONSOLE BOX DUCT  (See REMOVAL )
  11. REMOVE ENGINE NO. 2 UNDER COVER 
  12. REMOVE FRONT EXHAUST PIPE ASSEMBLY 
    1. Remove the front exhaust pipe (See REMOVAL ).
  13. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR  (See REMOVAL )
  14. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY 
    1. Move the shift lever to the N position.
    2. Remove the nut and disconnect the floor shift gear shifting rod.
  15. REMOVE FLOOR SHIFT ASSEMBLY 
    1. Disconnect the 2 connectors.
    2. Disconnect the 6 clamps.
      Fig 2: Locating Floor Shift Gear Shifting Rod Nut
      G05288267Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 4 bolts.
    4. Remove the floor shift assembly.
About FixVault