How To Proceed With Troubleshooting

HINT:

• Use these procedures to troubleshoot the intuitive parking assist system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 11 to 14 V 

   If the voltage is below 1 V, recharge or replace the battery before proceeding.

3. CHECK AND CLEAR DTC* 
   1. Refer to the DTC CHECK / CLEAR  .
4. CHECK INITIAL CHECK FUNCTION 
   1. Refer to OPERATION CHECK  .

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      Symptom does not occur	A
      Symptom occurs	B

   B:  Go to step  6

   A: Go to next step 

5. SYMPTOM SIMULATION 
6. CHECK MULTIPLEX COMMUNICATION SYSTEM* 
   1. Refer to how to proceed with troubleshooting (see HOW TO PROCEED WITH TROUBLESHOOTING ).

      HINT:

      This ECU is connected to the multiplex communication system. Therefore, be sure to check that there are no problems in the multiplex communication system before performing troubleshooting.

7. CHECK CAN COMMUNICATION SYSTEM* 
   1. Refer to how to proceed with troubleshooting (see HOW TO PROCEED WITH TROUBLESHOOTING ).

      HINT:

      This ECU is connected to the CAN communication system. Therefore, be sure to check that there are no problems in the CAN communication system before performing troubleshooting.

8. DTC CHECK* 
   1. Refer to the DTC CHECK / CLEAR  .

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      DTC is output	A
      DTC is not output	B

   B:  Go to step  10

   A: Go to next step 

9. DTC CHART 
   1. Refer to the DIAGNOSTIC TROUBLE CODE CHART  .

   NEXT:  Go to step  11

10. PROBLEM SYMPTOMS TABLE 
    1. Refer to the PROBLEM SYMPTOMS TABLE  .
11. CIRCUIT INSPECTION 
12. IDENTIFICATION OF PROBLEM 
13. REPAIR OR REPLACE 
14. CONFIRMATION TEST 

    NEXT: END