FixVault
Home › Lexus › 2008 › GS 450h › Repair and Diagnosis › Accessories & Equipment › Entertainment Systems › Audio/Visual › Radio Receiver › Removal

Radio Receiver: Removal

  1. SET RADIO RECEIVER ASSEMBLY TO SHIPMENT MODE 
    1. Remove all discs and tape.
      NOTE: If the discs or tape cannot be removed, do not attempt to remove them forcibly. Send the unit to a repair shop.
    2. Turn the power switch OFF.
    3. While simultaneously pressing the "SEEK UP" and "DISC" switches, turn the power switch ON (ACC).
      Fig 1: Locating SEEK UP And DISC Switches
      G05819742Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT:

      The CD loading door indicator light blinks during mode setting and it remains lit after the setting is completed.

    4. Turn the power switch OFF.
      5. Fig 2: Identifying CD Loading Door Indicator Light In Blinking Position
      G05819743Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  3. REMOVE FRONT CONSOLE UPPER PANEL GARNISH  (See REMOVAL )
  4. REMOVE CONSOLE UPPER PANEL ASSEMBLY  (See REMOVAL )
  5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH  (See REMOVAL )
  6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH  (See REMOVAL )
  7. REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY 
    1. Remove the 4 bolts.
      Fig 3: Locating Multi-Display With Radio Receiver Assembly Bolts
      G05819744Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Pull the multi-display with radio receiver to detach the 2 clips on the backside of the multi-display.
    3. Disconnect the connectors and remove the multi-display with radio receiver.
      Fig 4: Removing Multi-Display With Radio Receiver
      G05819745Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. CONFIRM RADIO RECEIVER ASSEMBLY SHIPMENT MODE SETTING 
    1. Look at the backside of the radio receiver and check that a metal plate can be seen through the hole near the "SHIP" mark.
      NOTE: If a metal plate cannot be seen, perform the shipment mode setting again.
      Fig 5: Identifying SHIP Mark
      G05819746Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE NO. 2 RADIO BRACKET 
    1. Remove the 5 bolts and bracket.
      Fig 6: Locating No. 2 Radio Bracket Bolts
      G05819747Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE NO. 1 RADIO BRACKET 
    1. Remove the 5 bolts and bracket.
      2. Fig 7: Locating No. 1 Radio Bracket Bolts
      G05819748Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault