Inspection Procedure

1. Disconnect the navigation ECU connector and multi-display connector.
   Fig 1: Identifying H2 Multi-Display Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value (s) in the table below.

   Standard resistance 

   STANDARD RESISTANCE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   L113-1 (GVI+) - h2-1 (GVI+)	Always	Below 1 Ω
   L113-2 (GVI-) - h2-2 (GVI-)	Always	Below 1 Ω
   L113-3 (GND) - h2-3 (GVG1)	Always	Below 1 Ω
   L113-1 (GVI+) - Body ground	Always	10 kΩ or higher
   L113-2 (GVI-) - Body ground	Always	10 kΩ or higher

Fig 2: Identifying L113 Navigation ECU Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE