FixVault
Home › Lexus › 2008 › GS 460 › Repair and Diagnosis › Accessories & Equipment › Entertainment Systems › Audio/Visual › Network Gateway Ecu › Installation

Network Gateway Ecu: Installation

  1. INSTALL NETWORK GATEWAY ECU 
    1. Install the ECU.
    2. Attach the 2 claws to install the cover.
    3. Connect the connector.
  2. INSTALL GLOVE COMPARTMENT DOOR SUB-ASSEMBLY  (See INSTALLATION )
  3. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY  (See INSTALLATION )
    Fig 1: Identifying Network Gateway ECU Claws
    G05299628Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL INSTRUMENT SIDE PANEL RH  (See INSTALLATION )
  6. INSTALL FRONT DOOR OPENING TRIM COVER RH  (See INSTALLATION )
  7. INSTALL FRONT DOOR SCUFF PLATE RH  (See INSTALLATION )
  8. INSTALL INSTRUMENT PANEL FINISH PANEL END RH  (See INSTALLATION )
  9. INSTALL CONSOLE UPPER PANEL ASSEMBLY  (See INSTALLATION )
  10. INSTALL FRONT CONSOLE UPPER PANEL GARNISH  (See INSTALLATION )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  12. PERFORM INITIALIZATION 
    1. Perform initialization (See INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  13. CHECK SRS WARNING LIGHT 
    1. Check SRS warning light (See PRECAUTION ).
About FixVault