FixVault
Home › Lexus › 2008 › GS 460 › Repair and Diagnosis › Accessories & Equipment › Entertainment Systems › Audio/Visual › Radio Receiver › Removal

Radio Receiver: Removal

  1. SET RADIO RECEIVER ASSEMBLY TO SHIPMENT MODE 
    1. Remove all discs and tapes.
      NOTE: If the discs or tapes cannot removed, do not attempt to remove them forcibly. Send the unit to a repair shop.
    2. Turn the engine switch off.
    3. While simultaneously pressing the "SEEK UP" and "DISC" switches, turn the engine switch on (ACC).
      Fig 1: Locating SEEK UP And DISC Switches
      G05300353Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT:

      The CD loading door indicator light blinks during mode setting and it remains lit after the setting is completed.

    4. Turn the engine switch off.
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
    Fig 2: Identifying CD Loading Door Indicator Light In Blinking Position
    G05299669Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FRONT CONSOLE UPPER PANEL GARNISH  (See REMOVAL )
  4. REMOVE CONSOLE UPPER PANEL ASSEMBLY  (See REMOVAL )
  5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH  (See REMOVAL )
  6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH  (See REMOVAL )
  7. REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY 
    1. Remove the 4 bolts.
      Fig 3: Locating Multi-Display With Radio Receiver Assembly Bolts
      G05299587Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Pull the multi-display with radio receiver to detach the 2 clips on the backside of the multi-display.
    3. Disconnect the connectors and remove the multi-display with radio receiver.
      Fig 4: Removing Multi-Display With Radio Receiver
      G05299588Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. CONFIRM RADIO RECEIVER ASSEMBLY SHIPMENT MODE SETTING 
    1. Look at the backside of the radio receiver and check that a metal plate can be seen through the hole near the "SHIP" mark.
      NOTE: If a metal plate cannot be seen, perform the shipment mode setting again.
      Fig 5: Identifying SHIP Mark
      G05299589Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE NO. 2 RADIO BRACKET 
    1. Remove the 5 bolts and bracket.
      Fig 6: Locating No. 2 Radio Bracket Bolts
      G05299590Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE NO. 1 RADIO BRACKET 
    1. Remove the 5 bolts and bracket.
  11. REMOVE MULTI-DISPLAY 
  12. REMOVE RADIO RECEIVER ASSEMBLY 
About FixVault