How To Proceed With Troubleshooting

Perform troubleshooting according to the following flowchart.

HINT:

• For further details, see the page given.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT 

2. CHECK DTC AND FREEZE FRAME DATA* 
   1. Record DTCs and freeze frame data.

   NEXT 

3. CLEAR DTC AND FREEZE FRAME DATA* 

   NEXT 

4. PROBLEM SYMPTOM CONFIRMATION 

   SYMPTOM DOES NOT OCCUR (GO TO STEP 5) 

   SYMPTOM OCCURS (GO TO STEP  6)

5. SYMPTOM SIMULATION 

   NEXT 

6. CHECK DTC* 
   1. Recheck for DTCs.

      HINT:

      • Refer to the diagnostic trouble code chart if any DTCs are output.
      • If any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first (See HOW TO PROCEED WITH TROUBLESHOOTING ).
      • If communication to the power steering ECU assembly is not established through the Techstream, inspect terminals SIL of the DLC3 and power steering ECU assembly, and inspect the IG circuit of the power steering ECU assembly.

   NORMAL SYSTEM CODE IS OUTPUT: GO TO STEP 7 

   TROUBLE CODE IS OUTPUT:  GO TO STEP  8

7. PROBLEM SYMPTOMS TABLE 

   NEXT 

8. DTC CHART 

   NEXT 

9. CIRCUIT INSPECTION* 

   NEXT 

10. IDENTIFICATION OF PROBLEM 

    NEXT 

11. REPAIR OR REPLACE 

    NEXT 

12. CONFIRMATION TEST 

    NEXT : END