Inspection Procedure

CHECK NAVIGATION SETTINGS
1. Enter the "Menu" screen by pressing the "MENU" switch.
2. Select "Set up".
  
  Fig 1: Identifying Tester Display - Set Up
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Check that "Voice Recognition Guidance" is not OFF.
  
  Fig 2: Checking Voice Recognition Guidance Is Not OFF
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  OK: Voice Recognition Guidance is not OFF.
  
  NG: TURN VOICE RECOGNITION GUIDANCE "ON"
  
  OK: Go to Next Step
CHECK MAP DISC
1. Check that the map disc is not deformed or cracked.
  
  Fig 3: Checking If Disc Is Deformed Or Cracked
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  OK: No deformations or cracks on map disc.
  
  NG: REPLACE MAP DISC
  
  OK: Go to Next Step
CHECK MAP DISC
1. Check for dirt on the map disc surface.
  OK: No dirt is on the map disc surface.
  
  HINT:
  
  If the disc is dirty, clean the disc by wiping the disc surface radially with a soft cloth.
  
  Fig 4: Cleaning Disc Surface With Soft Cloth
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE: Do not use a conventional record cleaner or antistatic preservative.
  
  NG: CLEAN MAP DISC
  
  OK: Go to Next Step
CHECK MICROPHONE (NAVIGATION CHECK MODE)
1. Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode (See NAVIGATION CHECK MODE ).
  
  Fig 5: Identifying Diagnostic Tool Display - Microphone & Voice Recognition Check
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. When a voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
3. Push the recording switch and perform voice recording.
  HINT:
  
  The recording limit is 5 seconds.
4. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.
  OK: All check results are normal.
  
  NG: PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE
  
  OK: END