FixVault
Home › Lexus › 2008 › IS 250 AWD › Repair and Diagnosis › Engine Performance › Fuel Delivery › Fuel (4GR-FSE) › Fuel Pressure Sensor › Installation

Fuel Pressure Sensor: Installation

  1. INSTALL FUEL PRESSURE SENSOR 
    1. Install a new gasket to the fuel pressure sensor.
    2. Using SST, install the fuel pressure sensor to the No. 1 delivery pipe.

      SST 09922-10010 

      Torque: For Use With SST 

      24 N*m (240 kgf*cm, 18 ft.*lbf) 

      For Use Without SST 

      31 N*m (316 kgf*cm, 23 ft.*lbf) 

      HINT:

      The torque for use with SST is the torque when SST is used at the position shown in the illustration.

      Fig 1: Installing Fuel Pressure Sensor To No. 1 Delivery Pipe
      G05826370Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the connector with the clamp.
      4. Fig 2: Locating Connector And Clamp
      G05286990Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL NO. 1 FUEL PIPE  (See INSTALLATION  )
  3. CONNECT WATER HOSE JOINT  (See INSTALLATION  )
  4. INSTALL INTAKE MANIFOLD  (See INSTALLATION  )
  5. INSTALL INTAKE AIR SURGE TANK  (See INSTALLATION  )
  6. INSTALL COLD START INJECTOR  (See INSTALLATION  )
  7. INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY  (See INSTALLATION )
  8. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE  (See INSTALLATION )
  9. CONNECT NO. 2 VENTILATION HOSE  (See INSTALLATION )
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL  (See INSTALLATION )
  11. ADD ENGINE COOLANT  (See ON-VEHICLE INSPECTION )
  12. INSPECT FOR COOLANT LEAK  (See ON-VEHICLE INSPECTION )
  13. INSPECT FOR FUEL LEAK  (See ON-VEHICLE INSPECTION  )
  14. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See INSTALLATION )
  15. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See INSTALLATION )
  16. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See INSTALLATION )
  17. INSTALL FRONT WIPER ARM HEAD CAP  (See INSTALLATION )
  18. INSTALL ROOF DRIP SIDE FINISH MOLDING LH 
  19. INSTALL ROOF DRIP SIDE FINISH MOLDING RH 
  20. INSTALL FRONT UPPER FENDER PROTECTOR LH  (See INSTALLATION )
  21. INSTALL FRONT UPPER FENDER PROTECTOR RH 

    HINT:

    Installation procedure of the RH side is the same as that of the LH side.

  22. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  23. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  24. INSTALL ENGINE ROOM SIDE COVER RH  (See INSTALLATION )
  25. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  26. CHECK FUNCTION OF THROTTLE WITH MOTOR BODY ASSEMBLY  (See ON-VEHICLE INSPECTION )
  27. PERFORM INITIALIZATION 
    1. Perform initialization (See INITIALIZATION ).

      HINT:

      Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.

About FixVault