FixVault
Home › Lexus › 2008 › IS 250 AWD › Repair and Diagnosis › Engine Performance › Fuel Delivery › Fuel (4GR-FSE) › Fuel Pressure Sensor › Removal

Fuel Pressure Sensor: Removal

  1. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  2. REMOVE ENGINE ROOM SIDE COVER LH  (See REMOVAL )
  3. REMOVE ENGINE ROOM SIDE COVER RH  (See REMOVAL )
  4. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE FRONT UPPER FENDER PROTECTOR LH  (See REMOVAL )
  6. REMOVE FRONT UPPER FENDER PROTECTOR RH 

    HINT:

    Removal procedure of the RH side is the same as that of the LH side.

  7. REMOVE ROOF DRIP SIDE FINISH MOLDING LH  (See REMOVAL )
  8. REMOVE ROOF DRIP SIDE FINISH MOLDING RH 

    HINT:

    Removal procedure of the RH side is the same as that of the LH side.

  9. REMOVE FRONT WIPER ARM HEAD CAP  (See REMOVAL )
  10. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See REMOVAL )
  11. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See REMOVAL )
  12. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See REMOVAL )
  13. DISCHARGE FUEL SYSTEM PRESSURE 

    HINT:

    See PRECAUTION  .

  14. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  15. DRAIN ENGINE COOLANT  (See ON-VEHICLE INSPECTION )
  16. DISCONNECT NO. 2 VENTILATION HOSE  (See REMOVAL )
  17. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE ASSEMBLY  (See REMOVAL )
  18. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY  (See REMOVAL )
  19. REMOVE COLD START INJECTOR  (See REMOVAL  )
  20. REMOVE INTAKE AIR SURGE TANK  (See REMOVAL  )
  21. REMOVE INTAKE MANIFOLD  (See REMOVAL  )
  22. DISCONNECT WATER HOSE JOINT  (See REMOVAL  )
  23. REMOVE NO. 1 FUEL PIPE  (See REMOVAL  )
  24. REMOVE FUEL PRESSURE SENSOR 
    1. Disconnect the connector and clamp.
    2. Remove the fuel pressure sensor and gasket.
      Fig 1: Locating Fuel Pressure Sensor
      G05286987Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault