FixVault
Home › Lexus › 2008 › IS 250 AWD › Repair and Diagnosis › External Pages › Different car › Section 12 (Engine Mechanical) › Drive Belt › Installation

Drive Belt: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL V-RIBBED BELT 
    1. Install the V-ribbed belt as shown in the illustration
    2. Rotate the V-ribbed belt tensioner pulley counterclockwise, and then remove the bar.
      NOTE: Check that the drive belt is properly set to each pulley.
      Fig 1: V-Ribbed Belt Routing
      G05749387Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Check that the belt is properly positioned on each pulley.
    4. Start the engine and check that the belt turns smoothly and no abnormal noise occurs.
    Fig 2: Identifying Proper Position Of V-Ribbed Belt
    G05129194Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL RADIATOR RESERVE TANK ASSEMBLY 
    1. Install the radiator reserve tank assembly with the 2 bolts.

      Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

  3. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
  4. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
Fig 3: Locating Radiator Reserve Tank Bolts
G05749384Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault