Satellite Switch: Inspection

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT SATELLITE SWITCH

Disconnect the J16 connector.

Measure the resistance according to the value(s) in the table below

Standard Resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Switch Condition	Specified Condition
2 (LSEL) - 5 (E)	Satellite switch LH is pressed	Below 1 Ω
2 (LSEL) - 5 (E)	Satellite switch LH is not pressed	10 kΩ or higher
3 (SET)- 5 (E)	Satellite switch ON/OFF is pressed	Below 1 Ω
3 (SET) - 5 (E)	Satellite switch ON/OFF is not pressed	10 kΩ or higher
4 (RSEL) - 5 (E)	Satellite switch RH is pressed	Below 1 Ω
4 (RSEL) - 5 (E)	Satellite switch RH is not pressed	10 kΩ or higher

HINT.

If the value is not as specified, replace the satellite switch (See REMOVAL )

Fig 1: Identifying Satellite Switch