FixVault
Home › Lexus › 2008 › IS 250 AWD › Repair and Diagnosis › Transmission › Transfer Case › UF1AE Transfer Case › Transfer Control Solenoid › Installation

Transfer Control Solenoid: Installation

  1. INSTALL TRANSFER CONTROL SOLENOID 
    1. Install the transfer control solenoid and solenoid lock plate to the transfer upper valve body with the bolt.

      Torque: 6.4 N*m (65 kgf*cm, 57 in.*lbf) 

      HINT:

      Install the solenoid lock plate into the cutout on the transfer control solenoid.

      Fig 1: Installing Transfer Control Solenoid
      G05295914Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL TRANSFER VALVE BODY ASSEMBLY  (See REMOVAL  )
  3. INSTALL TRANSFER OIL PAN  (See INSTALLATION  )
  4. INSTALL TRANSFER DYNAMIC DAMPER  (See INSTALLATION  )
  5. INSTALL ENGINE REAR MOUNTING MEMBER  (See INSTALLATION  )
  6. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR  (See INSTALLATION )
  7. INSTALL FRONT EXHAUST PIPE ASSEMBLY  (See INSTALLATION )
  8. INSTALL HEATED OXYGEN SENSOR  (See INSTALLATION )
  9. INSTALL FRONT CENTER FLOOR BRACE  (See INSTALLATION )
  10. INSTALL REAR NO. 1 FLOOR PANEL BRACE  (See INSTALLATION )
  11. ADD AUTOMATIC TRANSMISSION FLUID  (See ADJUSTMENT )
  12. CHECK FOR EXHAUST GAS LEAKS 
About FixVault