FixVault
Home › Lexus › 2008 › IS 250 RWD, Automatic › Repair and Diagnosis › Transmission › Automatic Trans › A960E Automatic Transaxle › Pattern Select Switch › Inspection

Pattern Select Switch: Inspection

  1. INSPECT PATTERN SELECT SWITCH 
    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

    STANDARD RESISTANCE SPECIFICATION

    Switch Condition Tester Connection Specified Condition
    Pattern select switch (PWR) 3 - 7 Below 1 Ω
    Pattern select switch (NORM) 3 - 7 10 kΩ or higher
    Press continuously
    Pattern select switch (SNOW)    		 1 - 3 Below 1 Ω
    Release Pattern select switch (SNOW) 1 - 3 10 kΩ or higher

    If the resistance value is not as specified, replace the pattern select switch.

    Fig 1: Identifying Pattern Select Switch Connector
    G05318238Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault