FixVault
Home › Lexus › 2008 › IS 350 › Repair and Diagnosis › Body & Frame › Door Locks › Door Lock › Entry Lock And Unlock Switch › Installation

Entry Lock And Unlock Switch: Installation

  1. INSTALL FRONT DOOR OUTSIDE HANDLE SUB-ASSEMBLY 
    1. Insert the front end of the front door outside handle sub-assembly in to the front door out side handle frame.
    2. Insert the rear end of the front door outside handle assembly into the front door outside handle frame. Next slide the front door outside handle assembly to the front of the vehicle to install it.
      Fig 1: Installing Front Door Outside Handle Sub-Assembly
      G05252823Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Using a "torx" socket wrench (T30), install the front door outside handle sub-assembly with the screw.
    4. Connect the connector.
      5. Fig 2: Locating Front Door Connector With Screws
      G05320750Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FRONT DOOR OUTSIDE HANDLE COVER  (See REASSEMBLY )
  3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY  (See REASSEMBLY )
  4. INSTALL FRONT DOOR SERVICE HOLE COVER  (See REASSEMBLY )
  5. INSTALL FRONT DOOR TRIM COVER  (See REASSEMBLY )
  6. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY  (See REASSEMBLY )
  7. INSTALL COURTESY LIGHT ASSEMBLY  (See REASSEMBLY )
  8. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY  (See REASSEMBLY )
  9. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG  (See REASSEMBLY )
About FixVault