FixVault
Home › Lexus › 2008 › IS 350 › Repair and Diagnosis › External Pages › Different car › Section 22 (Automatic Transaxle) › Shift Lever › Installation

Shift Lever: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY 
    1. Install the floor shift assembly with the 4 bolts

      Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf) 

    2. Connect the 4 clamps to the floor shift assembly
    3. Connect the 2 connectors to the floor shift assembly
      Fig 1: Locating Floor Shift Assembly Connector With Clamps
      G05750931Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY 
    1. Temporarily tighten the floor shift gear shifting rod with the nut

      HINT

      The rod is tightened to a torque specification in the "ADJUST SHIFT LEVER POSITION" procedure

      2. Fig 2: Locating Shift Lever Nut
      G05750919Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. ADJUST SHIFT LEVER POSITION  (See ADJUSTMENT  )
  4. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR  (See INSTALLATION )
  5. INSTALL FRONT EXHAUST PIPE ASSEMBLY  (See INSTALLATION )
  6. CONNECT HEATED OXYGEN SENSOR  (See INSTALLATION )
  7. INSTALL FRONT CENTER FLOOR BRACE  (See INSTALLATION )
  8. INSTALL REAR NO. 1 FLOOR PANEL BRACE  (See INSTALLATION )
  9. INSTALL TAIL EXHAUST PIPE ASSEMBLY  (See INSTALLATION )
  10. INSTALL NO. 2 FLOOR UNDER COVER  (See INSTALLATION )
  11. INSTALL NO. 1 FLOOR UNDER COVER  (See INSTALLATION )
  12. INSTALL NO. 2 CONSOLE BOX DUCT  (See INSTALLATION )
  13. INSTALL CONSOLE BOX  (See INSTALLATION )
  14. INSTALL CONSOLE BOX REGISTER ASSEMBLY  (See INSTALLATION )
  15. INSTALL REAR ASH RECEPTACLE ASSEMBLY  (See INSTALLATION )
  16. INSTALL FRONT ASH RECEPTACLE ASSEMBLY  (See INSTALLATION )
  17. INSTALL CONSOLE PANEL SUB-ASSEMBLY  (See INSTALLATION )
  18. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH  (See INSTALLATION )
  19. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH  (See INSTALLATION )
  20. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY  (See INSTALLATION )
  21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  22. INSPECT SHIFT LEVER POSITION  (See ON-VEHICLE INSPECTION  )
  23. INSPECT FOR EXHAUST GAS LEAK 
About FixVault