Confirmation Driving Pattern

HINT.

Performing this confirmation pattern will activate the mass air flow performance monitor.

Fig 1: Vehicle Speed - Driving Pattern

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect the Techstream to the DLC3
2. Turn the engine switch on (IG)
3. Turn the Techstream ON
4. Clear DTCs (See DTC CHECK/CLEAR )
5. Start the engine, and warm it up until the engine coolant temperature reaches 70°C (158°F) or higher
6. Drive the vehicle at approximately 62 mph (100 km/h) for 20 seconds or more
7. Enter the following menus. Powertrain / Engine / Trouble Codes, then check if any DTCs (any pending DTCs) are set.