Inspection Procedure

Refer to DTC P0710 

1. CHECK DTC OUTPUT (IN ADDITION TO DTC P0711) 
   1. Connect the Techstream to the DLC3
   2. Turn the engine switch on (IG)
   3. Turn the Techstream on
   4. Enter the following menus- Powertrain / ECT / Trouble Codes.
   5. Read the DTCs using the Techstream

      Result 

      RESULT REFERENCE
      
      

      Display (DTC Output)	Proceed to
      Only P0711 is output	A
      P0711 and other DTC	B

      HINT.

      If any other codes besides P0711 are output, perform troubleshooting for those DTCs first.

   B: GO TO DTC CHART  (See DIAGNOSTIC TROUBLE CODE CHART  )

   A: Go to next Step 

2. CHECK TRANSMISSION FLUID LEVEL 
   1. Check the transmission fluid level (See AUTOMATIC TRANSMISSION FLUID  ).

      OK: Automatic transmission fluid level is correct. 

   NG: ADJUST FLUID LEVEL  (See AUTOMATIC TRANSMISSION FLUID  )

   OK: REPLACE TRANSMISSION WIRE (ATF TEMPERATURE SENSOR)  (See REMOVAL  )