FixVault
Home › Lexus › 2008 › LS 600hL › Repair and Diagnosis › Body & Frame › Door Locks › Door Lock › Door Control Receiver › Installation

Door Control Receiver: Installation

  1. INSTALL DOOR CONTROL RECEIVER 
    1. Install the receiver with the nut.
    2. Connect the connector
      NOTE: When replacing or inspecting the door control receiver and wire harness, do not change the position or length of the wire harness. If the wire harness is too close to the door control receiver, entry and wireless function performance may be affected.
      Fig 1: Locating Door Control Receiver Connector And Nut
      G05783286Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH  (See INSTALLATION )
  3. INSTALL REAR FLOOR FINISH PLATE  (See INSTALLATION )
  4. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER  (See INSTALLATION )
  5. INSTALL NO. 1 COOLER COVER (w/ Rear Cooler)  (See INSTALLATION )
  6. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY  (See INSTALLATION )
  7. INSTALL DECK TRIM SIDE BOARD RH  (See INSTALLATION )
  8. INSTALL ROPE HOOK ASSEMBLY  (See INSTALLATION )
  9. INSTALL ROPE HOOK  (See INSTALLATION )
  10. INSTALL BATTERY SERVICE HOLE COVER  (See INSTALLATION )
  11. INSTALL BATTERY SERVICE HOLE COVER LH  (See INSTALLATION )
  12. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See INSTALLATION )
About FixVault