FixVault
Home › Lexus › 2008 › LS 600hL › Repair and Diagnosis › Engine Mechanical › Auxiliary Emission Control Systems › Emission Control › Fuel Tank Pressure Sensor › Removal

Fuel Tank Pressure Sensor: Removal

  1. REMOVE FUEL TANK ASSEMBLY 
    1. Remove the fuel tank from the vehicle (see REMOVAL ).
  2. REMOVE NO. 3 FUEL TANK PROTECTOR 
    1. Release the lock and then turn the protector and remove it.
      2. Fig 1: Removing No. 3 Fuel Tank Protector
      G05773172Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FUEL TANK PRESSURE SENSOR 
    1. Disconnect the pressure sensor connector
    2. Remove the tube joint clip and pressure sensor.
      NOTE:
      • Before removing the tube joint clip, check for foreign matter around the tube joint clip. Clean if necessary.
      • Keep the O-ring free of foreign matter, as it becomes contaminated easily.
      • Do not use any tools in this procedure.
      • Be careful not to damage the tube joint clip. If the tube joint clip is damaged, replace it.
        Fig 2: Removing Tube Joint Clip And Pressure Sensor
        G05303392Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE FUEL TANK BREATHER TUBE GASKET 
    1. Remove the 4 screws, fuel tank protector plate, fuel tank EVAP tube support plate and gasket
      Fig 3: Locating Fuel Tank Breather Tube Gasket Screws
      G05303393Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault